PTS Dead Air Sandman Mock Suppressor

The Sandman-K is the compact one at 148mm, short enough to clear a mid-length handguard without overhanging the rail. The Sandman-S steps up to 180mm for the classic carbine silhouette, and the Sandman-L is the long version in the family, aimed at DMR and support builds where the extra length reads correctly.

All three share the same construction: a 6000 series aluminium body over steel internals, finished in a flat non-reflective coat. That combination keeps the weight sensible on the end of an outer barrel while leaving the thread collar hard enough to take repeated fitting and removal.

Fitment is identical across the range. Every model threads 14mm counter-clockwise, which is the standard on the overwhelming majority of airsoft rifles sold in the UK, and all three accept the Dead Air Keymo and KeyMicro muzzle device series if you want a quick-detach mount rather than a direct thread.

Specifications

Good to know before you buy

Length changes the balance, not the performance. A mock suppressor sits at the very end of the barrel, so every extra centimetre is felt as muzzle weight rather than as bulk. If you shoulder the gun a lot, the Sandman-K keeps the point of balance where it already is; the longer two shift it forward, which some players prefer for a steadier hold off a bipod or a wall.

The Sandman-K and Sandman-S come with a three-prong flash hider. It threads on under the suppressor body, so you can run the gun with the hider alone when you want the shorter profile, then put the can back on for a game. If you only want the hider, the flash hiders section has standalone options.

Check your muzzle thread before ordering. 14mm counter-clockwise is the airsoft standard and covers nearly every AEG and gas rifle on the UK market, but a handful of pistols and a few older platforms use a clockwise thread instead. A thread adaptor converts between the two, and the rest of the range sits in suppressors.

Frequently asked questions

Will a mock suppressor make my gun quieter?
No, and it is not meant to. A mock suppressor is a cosmetic and ergonomic part: it changes the look and the length of the gun, and on some platforms it takes the edge off the crack of the muzzle, but it does not meaningfully reduce the sound and it will not affect your chronograph reading.

Which model should I pick?
Go by the gun. The Sandman-K at 148mm suits carbines and anything with a mid-length handguard. The Sandman-S at 180mm gives the traditional suppressed-carbine look. The Sandman-L is the long version, aimed at DMR and support builds — the manufacturer does not publish a figure for its length, so ask us before ordering if you are fitting it into a tight overall length.

Does it fit my rifle?
If your outer barrel is threaded 14mm counter-clockwise, yes, and that covers the large majority of airsoft rifles. All three models also take the Dead Air Keymo and KeyMicro muzzle devices if you want a quick-detach mount. For a 14mm clockwise thread you will need an adaptor first.

Can I put a tracer unit inside it?
No. These are solid mock suppressors, not tracer housings, so there is no space or electronics inside for a tracer module. If you want tracer rounds, fit a dedicated unit from the tracer units range instead.