Wolverine MTW Advanced Electronics Wire Harness

Wiring is the least glamorous part of an HPA build and the one most likely to strand you. A harness lives inside the receiver, gets flexed every time the gun is stripped, and eventually a conductor fatigues or a connector works loose. The gun then behaves erratically in a way that looks like an electronics fault rather than a wiring one.

This is the genuine Wolverine harness for the MTW Advanced Electronics Kit — the upgrade that takes a Billet MTW up to Forged-series electronics. It is the correct length and connector set for that installation, which matters more than it sounds: a harness that is close but not right leaves you either stretching a loom or cramming slack somewhere it will chafe.

Useful either as a replacement for a damaged loom, or as a spare if you build and rebuild MTWs regularly.

Specifications

Good to know before you buy

This is the harness for the Advanced Electronics Kit specifically. Wolverine make different looms for V2, V3 and M249 conversions, and they are not interchangeable — check which you need before ordering, or send us your setup and we will confirm.

Frequently asked questions

How do I know the harness is the problem?
Intermittent trigger response, the gun cutting out when the receiver is flexed, or electronics that behave differently after a strip and rebuild. Wiring faults usually move with the gun rather than staying constant.

Will it fit a standard MTW?
It is for the Advanced Electronics Kit. If you are running standard MTW electronics, tell us and we will identify the right loom.

Is it hard to fit?
It means opening the receiver and routing the loom correctly. Straightforward if you have done it, and we handle it on the bench if not.